262335 46 Revision A
3.12.3 Attaching A40D Header to an M200 Windrower
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator’s seat for any reason.
Figure 3.74: Drive Hoses
The M200 Windrower requires four drive hoses (A) to run an
A40D Auger Header. An electrical harness (B) is located on the
left side of the windrower.
Figure 3.75: Auger Header Drive and Draper Header
Reel Drive and Lift Plumbing Kit (B4651)
If only three drive hoses are present, before following the
procedure below, configure the M200 to run an A40D Auger
Header by installing kit B4651. The kit includes an additional
hose (A), hardware, and installation instructions.
ASSEMBLING THE MACHINE
To Next Page
Loading...
