Installation of Echo™ Software
F6 SMART™ – Volumetric Handheld Camera – User Guide
WARNING:
If the scanning data files’ repository was set within the
directory (see paragraph “Setting the
Database Repository” on page 36 below), uninstalling
the Echo™ software application will
also delete the
Projects’ data files!
Make sure these data files are backed-up prior to the
execution of an uninstall procedure.
Updating/Upgrading the Echo™ Software
WARNING:
Since complete removal of the Echo™ software
application also deletes the Projects’ data files,
update/upgrade of new versions need to be done as
explained on page 26, where each new version
installed under a separated directory, each carrying
the software version number.
Based on the assumption that settings of the Database Repository, as well as the
Calibration Files’ Repository, were executed, in the preceding installation, as described in
paragraph Setting the Database Repository (see page 36 below), the procedure of
updating/upgrading the Echo™ software is done in a similar way to the initial installation
of the Echo™ software (described in Chapter 5 – Installation of Echo™ Software on page
24 above), except that:
● There is no need to re-install the FTDI CDM Device Drivers (see page 27 above).
● There is no need to re-install the Visual Studio™ Redistributable Packages (see page
27 above).
● The Destination Location (see page 25 above) will be different since the software
version number is different (to the previously installed Echo™ software).
To Next Page
Loading...