1-8
Stack Dryer Control Set-up Procedures
IMPORTANT: Read all instructions before
operating.
The fabric setting button along with the digital
display are used to set-up the dryer controls.
The display can contain 4 numbers and/or
letters and a decimal point. These are used
to indicate the set-up codes and related code
values available for use in programming the
dryer.
How to use the key pad to program the
controls
The WHITES & COLORS button is used
to adjust the values associated with set-up
codes. Pressing the button will increment
the value by one (1). Rapid adjustment is
possible by holding the button down.
The PERM. PRESS button advances the
display through the set-up codes. Pressing
the button will advance the display to the
next available set-up code. Holding the
button down will automatically advance
through the set-up codes at a rate of one (1)
per second.
The DELICATES button is used to select or
deselect options.
1.
2.
3.
Start Operating Set-Up
PD Models: Insert access door key, turn,
and lift to remove access door.
PN Models are equipped with programming
switches. Insert access panel key and turn
counter-clockwise.
PN Models: Once the debit card reader
is installed (according to the reader
manufacturer’s instructions), the set-
up mode can be changed by inserting
a manual set-up card (supplied by the
reader manufacturer) into the card slot. If
manual set-up card is not available, manual
set-up mode cannot be entered. Only
diagnostic mode can be entered using the
programming key or by removing connector
AA1 on the circuit board.
IMPORTANT: The console must not be
opened unless power is rst removed from the
dryer. To access connector AA1:
Unplug dryer or disconnect power.
Open console, disconnect jumper on AA1,
close console.
Plug in dryer or reconnect power.
The dryer is now in the set-up mode.
Before proceeding, it is worth noting that,
despite all the options available, an owner can
simply choose to uncrate a new commercial
dryer, hook it up, plug it in, and have a dryer
that operates.
NOTE: PD models require a coin drop to be
installed prior to installation.
PD dryers are pre-set at the factory for
fixed cycle price with top off.
PN dryers are pre-set for free cycle
operation so they can be run without
payment.
n
n
n
Ë
Ë
Ë
n
n
To Next Page
Loading...
