VX30/VX50 Gen3/ECO50 Vacuum Excavators Operating the Vacuum Excavator 50-15
Removing Debris From Spoil Tank
To transfer material from spoil tank to a designated area:
Step 1: Attac
h hose to Lower Gate/Drain valve (1).
Step 2: Ens
ure Reverse Flow Control is in NEUTRAL position.
Step 3: S
tart engine, and run in high speed.
Step 4: Mov
e Reverse Flow Control to Pressure position.
Step 5: Point
hose safely to designated dumping area. Open Lower Gate/Drain valve.
Step 6: Di
scharge material from spoil tank to designated area.
Step 7: Mov
e Reverse Flow Control to NEUTRAL position.
Step 8: Close
Lower Gate/Drain valve. Turn off engine.
At this point, operator can either resume work, or remov
e solid waste from the tank.
Refer to “Dumping Spoil Tank,” page 50-19.
To Next Page
Loading...
