60-14 Maintenance - 10 Service Hours or Daily VX30/VX50 Gen3/ECO50 Vacuum Systems
Machine - Clean
Clean machine daily at end of operation.
Door Seal - Clean
Clean door seal daily and after emptying the tank.
Tools - Clean/Check
Remove dirt and mud from tools daily. Do not allow mud to build up on the inside of the tool, which will restrict
the f
low of debris and reduce tool performance. Ensure nozzles are clean, unclogged, and working properly.
Replace nozzles as needed. Check fittings and condition of hoses daily. Tighten or replace as necessary. Replace
broken and worn-out tools.
Refer to “Machine - Clean,” p
age 50-22, for additional instructions.
Water Tank In-Line Strainer - Clean
Clean water strainer daily before starting the machine, or during operation if water flow becomes restricted.
Refer to “Water Tank In-Line Strainer - Clean,” page 40-17.
To Next Page
Loading...
