VX30/VX50 Gen3/ECO50 Vacuum Systems Welding Alert - Electronic Components 60-1
Section 60: Maintenance
Visually inspect machine daily before starting the machine.
Make no modifications to your equipment unless specifically recommended or requested
by Vermeer Corporation.
WELDING ALERT - ELECTRONIC COMPONENTS
NOTICE: Welding will damage electronic components. Using Battery Disconnect Switch to disconnect battery
ground will not prevent damage.
To prevent damage to electronic modules and
controllers, unplug them before welding. Observe the following
precautions:
• Do not clamp welding ground to
any electrical component.
• Clamp welding ground on the part being welded, or
as close to it as possible. Do not allow weld
current to pass through bearings or other moving components.
• Thoroughly clean the welding location and remove paint.
• Protect wiring and wiring harnesses from weld spatter.
• If welding an engine-mounted component,
remove it before welding.
• Use proper welding procedures.
WARNING: Failure to use shutdown procedure can result in unexpected hazard(s). Death or
serious injury could result due to entanglement, crushing, cutting, or other hazardous
contact. Follow Shutdown Procedure after operating, before performing any service or
maintenance, and before transporting. Refer to Shutdown Procedure, page 23-1.
To Next Page
Loading...
