Meggitt VM600 Hardware Manual

VM600 MPS hardware manual (standard version) MAMPS-HW/E v
Edition 17 - February 2018
The duly signed master copy of this page is stored by the Technical publications department of Meggitt SA
and can be obtained by writing to the Technical Publications Manager.
17 26.02.2018 Peter Ward
Added a statement that Meggitt SA product certifications
and warranties are valid only for products purchased
directly from Meggitt SA or an authorised distributor
(see IMPORTANT NOTICES).
Updated Figure 4-6 and Figure 5-3 to use “Alarm Reset”,
rather than “Latch reset or latch delay”.
Clarified the parameters that can be used for adaptive
monitoring (see 4.6.3 Adaptive monitoring).
Updated information on the channel inhibit function to
clarify its operation and reflect changes in the latest
versions of card firmware (see 4.6.6 Channel inhibit
function and 5.7.4 Channel inhibit function).
Updated status indicator LED information for the MPC4
card to include the behaviour for latched alarms (see
Figure 2-7 and 4.9 Operation of LEDs on MPC4 panel).
Updated status indicator LED information for the AMC8
card to include the behaviour for latched alarms (see
Figure 2-9 and 5.10 Operation of LEDs on AMC8 panel).
Updated the electrical circuit protection information to
include the improved RPS6U rack power supply
(see 8.3.2 Circuit breaker and 8.3.3 Supply wiring).
Added connection diagrams for measurement chains using
a GSI127 connected to an IOC4T card
(see 9.2.4.1 Voltage-modulated signal with GSI127
galvanic separation unit and 9.3.4.1 Voltage-modulated
signal with GSI127 galvanic separation unit).
Updated 9.7 DSI control inputs (DB, TM, AR) and 10.5 DSI
control inputs (DB, AR) to clarify the type of
Alarm Reset (AR) signal required.
Added information on the voltage and current limits of the
IOC4T card’s common reference/return (RET) signal
(see 9.5 Configuring the four DC outputs and 9.7 DSI
control inputs (DB, TM, AR)).
Clarified that the IOCN card’s group A and group B
connectors primarily support RS-485 communication
(see 13.6.3 RS, A and B connectors).
Added end-of-life product disposal information
(see 15 End-of-life product disposal).
Updated the Energy product return procedure and form to
be consistent with the Meggitt Vibro-Meter
®
website
(see 16 Service and support).
Updated the Power supply perturbation AC line frequencies
to use nominal values (see A.1 Overall).
PW
Department Name Date Signature
Technical content of original
issue approved by
Engineering Sylvain Queloz 17.10.2016 SQ
Product Management Michaël Hafner 23.02.2018 MH
Document released by Technical Publications Peter Ward 26.02.2018 PW
Edition
Date
of issue
Written by /
modified by
Description Signature

Meggitt VM600 Specifications

General

Brand	Meggitt
Model	VM600
Category	Measuring Instruments
Language	English