VM600 MPS hardware manual (standard version) MAMPS-HW/E ix
Edition 17 - February 2018
Part II: Installing VM600 MPS hardware and using the system
Part III: Maintenance and technical support
Part IV: Appendices
Chapter 8
Installation – Provides information on installing the cards and power supplies
in the VM600 MPS rack.
Chapter 9
Configuration of MPC4 / IOC4T cards – Describes the connectors on the
IOC4T card. Includes typical connection diagrams for measurement signal
sensors (for example, accelerometers, proximity probes) and speed signal
sensors. Contains information on attributing specific alarm signals to specific
relays on RLC16 cards using the Open Collector Bus and the Raw Bus.
Chapter 10
Configuration of AMC8 / IOC8T cards – Describes the connectors on the
IOC8T card. Includes typical connection diagrams for thermocouples, RTD
devices as well as other sensors providing a voltage-based or current-based
signal. Contains information on attributing specific alarm signals to specific
relays on RLC16 cards using the Open Collector Bus and the Raw Bus.
Chapter 11
Using the RLC16 card – Provides information on the screw terminal strips on
these relay cards.
Chapter 12
Using the IRC4 card – Provides information on the screw terminal strips on
these relay cards. Also contains information on attributing specific alarm
signals to specific relays on an IRC4 using the Open Collector and Raw
buses.
Chapter 13
Configuration of CPUM / IOCN cards – Contains details on configuring
jumpers on the two cards, as well as information on connectors.
Chapter 14
Maintenance and troubleshooting – Contains some basic tips for fault-finding.
Also includes information on long-term storage of racks.
Chapter 15
End-of-life product disposal – Provides information and contact details
concerning the environmentally friendly disposal of electrical/electronic
equipment at the end of its useful life.
Chapter 16
Service and support – Provides contact details for technical queries and
information concerning the repair and return of equipment.
Appendix A
Environmental specifications – Contains general environmental
specifications for the entire machinery protection system viewed as a whole.
Appendix B
Data sheets – Includes data sheet information for all cards and other system
components used in the VM600 MPS. The data sheets provide full electrical
and mechanical specifications, ordering information and so on.
Appendix C
Definition of backplane connector pins – Contains pin definitions for
connectors P1, P2, P3 and P4 for each slot in the ABE04x rack.
Appendix D
Abbreviations and symbols – Contains a list of abbreviations and
measurement unit symbols used in this document.
Product Defect Report
Allows the user to indicate problems observed on a
module/system component, thus enabling our
Customer support department to repair the equipment
as quickly as possible.
Documentation Evaluation Form
Allows the user to provide us with valuable feedback
on our documentation.
To Next Page
Loading...
Need help?
General
