EasyManuals Logo

mensor CPC6050 User Manual

mensor CPC6050
145 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
Operating Instructions - CPC6050 79
Modular Pressure Controller
CPC6050
Highspeed ON or OFF Sets the highspeed control mode,
which sets the control behavior, stable
window, stable delay, and rate set-
point
Highspeed? <sp>(YES or NO)<cr><lf> Returns the status of the highspeed
mode
Id? <sp>MENSOR,CPC6050,
ssssss,v.v.vv<cr><lf>
Ssssss is the serial number,v.v.vv is
the CPC6050 software version.
Instrument_control_
time_on?
<sp>NNNNN<cr><lf> Returns the amount of time the instru-
ment has been in control mode since
the last reset of the counter, in min-
utes
Instrument_total_con-
trol_time_on?
<sp>NNNNN<cr><lf> Returns the lifetime amount of time
the instrument has been in control
mode, in minutes
Instrument_time_on? <sp>NNNNN<cr><lf> Returns the amount of time the instru-
ment has been on since the last reset
of the counter, in minutes
Instrument_total_
time_on?
<sp>NNNNN<cr><lf> Returns the lifetime amount of time
the instrument has been on, in min-
utes
IP nnn.nnn.nnn.nnn Sets the IP address of the instrument
IP? <sp>nnn.nnn.nnn.nnn<cr><lf> Returns the IP address of the instru-
ment
Keylock YES or NO Locks or unlocks the entire touch
screen
Keylock? <sp>(YES or NO)<cr><lf> Returns Yes or No
Leak_Chan A, B Sets the leak channel over the bus
and makes that channel the active
remote channel
Leak_Chan? <sp>(A or B)<cr><lf> Returns the active leak channel
Leak_External ON or OFF Sets the leak test external valve set-
ting in Single output A or B mode only
Leak_External? <sp>(YES or NO)<cr><lf> Returns the leak test external valve
setting
Leak_Start Changes the screen to the Leak Test
if on another screen, begins the leak
test with current parameters.
Leak_Stop Stops the test and vents the system.
Leak_State? <sp>(IDLE or RUNNING or
COMPLETE)<cr><lf>
Returns state of the leak test
Leak_Setpt Value inside upper and lower limits Starting point for the leak test to begin
at
Leak_Setpt? <sp>n.nnnnnE+nn<cr><lf> Returns starting setpt
Leak_Dwell 0 to 3600 The duration of the test during which
a leak is measured

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the mensor CPC6050 and is the answer not in the manual?

mensor CPC6050 Specifications

General IconGeneral
Brandmensor
ModelCPC6050
CategoryController
LanguageEnglish

Related product manuals