© Microhard Systems Inc. 102
4.0 WebUI Configuration
4.10.4 Advanced > Event Reporting
Event Reporting allows the IPn3G to send periodic updates on the modem status via UDP packets. These
packets are customizable and can be sent to up to 4 different IP Addresses, at a programmable interval.
The event packet can report information about the modem such as the hardware and software versions,
core temperature, supply voltage, etc ; about the carrier such as signal strength (RSSI), phone number, RF
Band; or about the WAN such as if the assigned IP Address changes. All events are reported in binary.
Image 4-62: Advanced > Event Reporting submenu
4.10.4.1 Event Reporting > Configuration
Report#
This box allows the selection of the type of event to be reported. The
default is disabled. If Modem_event is selected, additional options appear
to the right and allow for customization of the event reported via Messages.
If Management is selected, additional check boxes appear below to select
the interfaces to report to the Microhard NMS system.
Values (selection)
Disable
Modem_Event
SDP_Event
Management
Remote IP
Enter the IP Address of a reachable host to send the UDP packets.
Values (IP Address)
0.0.0.0
To Next Page
Loading...
