© Microhard Systems Inc. 46
4.0 WebUI Configuration
Idle Time Out
The maximum amount of time to pass before modem will timeout. The
default is 0 seconds.
0-65535
Values (seconds)
Connect Time Out
The maximum amount of time to wait for a connection The default is 90
seconds.
0-65535
Values (seconds)
Dialing Max Retries
The maximum amount of attempts to dial and establish a connection. The
default is 0, which means that there is no maximum and the modem will
keep trying indefinitely.
0-100
Values
Authentication Type
Sets the authentication type required to negotiate with peer.
PAP - Password Authentication Protocol.
CHAP - Challenge Handshake Authentication Protocol.
NoAuth
pap
chap
pap-chap
Values (selection)
User Name
User Name as required for authentication to remote peer. May not be
required for dynamically assigned IP addresses from the wireless carrier.
Usually required for static IP addresses.
Carrier/peer dependant
Values (char string)
Dial-on-Demand
If disabled, the modem will always remain connected. The default is
Disabled.
Disable / Enable
Values (selection)
IP-Passthrough
IP pass-through allows the WAN IP address to be assigned to the device
connected to the rear Ethernet port on the IPn3G. In this mode the IPn3G
is transparent and forwards all traffic to the device connected to the
Ethernet port. The WebUI port (Default HTTP Port:80), this port is retained
for remote management of the IPn3G. This port can be changed to a
different port under the Security > Access Menu. It is recommended to
reboot the IPn3G after changing these settings.
Disable / Ethernet
Values (selection)
To Next Page
Loading...
