© Microhard Systems Inc. 118
4.0 WebUI Configuration
4.11.1.2 Backup Configuration Settings (FTP)
An FTP session can also be used to get the configuration file from the IPn3G. The following procedure can
be used:
Image 4-76: Tools > Maintenance > Configuration Backup (FTP)
1. From a DOS command prompt, start a FTP session with the IPn3G, you can FTP to the USB NDIS IP
Address, the LAN IP Address, and if the firewall settings allow, the WAN IP Address. The example
uses the USB NDIS Interface address:
2. Login using the username: upgrade and the password: admin
3. “Get” the file by specifiying the filename “system.conf” and the destination and destination filename
(use system.conf). In the example just the root directory of the PC is being used, so the destination is
c:\system.conf,
4. The Transfer should show as complete.
5. Navigate to the destination indicated on the PC and move/copy/edit as required.
1
2
3
4
To Next Page
Loading...
