Microhard Systems IPN3G - Page 126

© Microhard Systems Inc. 126
4.0 WebUI Configuration
Interfaces Select
The IPn3G can report information about the different interfaces it has. By
default the IPn3G is set to send information about the Carrier, such as
usage and RSSI. Statistical and usage data on USB, Ethernet and Serial
interfaces can also be reported.
The more that is reported, the more data that is sent to the NMS system,
be aware of data plan constraints and related costs.
Values (check boxes)
Ethernet
Carrier
USB
COM1
COM2
Status
The Web Service can be enabled or disabled. This service is used to
remotely control the IPn3G. It can be used to schedule reboots, firmware
upgrade and backup tasks, etc.
Values (chars)
Disable/Enable
Server Port
This is the port where the service is installed and listening. This port should
be open on any installed firewalls.
Values (Port#)
9998
Webclient Setting
Server Type
Select between HTTPS (secure), or HTTP server type.
Values (chars)
HTTPS/ HTTP
Username / Password
This is the username and password used to authenticate the unit.
Values (seconds)
admin/admin
Interval
The Interval defines how often the IPn3G checks with the NMS System to
determine if there are any tasks to be completed. Carrier data will be
consumed every time the device probes the NMS system.
Values (min)
60