Microhard Systems IPN3G - Page 140

© Microhard Systems Inc. 140
5.0 AT Commands
AT+MTWT
Command Syntax
Enable/Disable the Wireless Traffic Timeout.
Unit will reset if it does not see any traffic from
the carrier for the amount of time defined.
AT+MTWT=<value>
Value:
0 Disable
300 - 65535 (seconds)
Description
Example
Input:
AT+MTWT=300 <enter>
Response:
OK
AT+MCNTO
Command Syntax
Sets the timeout value for the serial and telnet
consoles. Once expired, user will be return to
login prompt.
AT+MCNTO=<Timeout_s>
0 - Disabled
0 - 65535 (seconds)
Description
Example
Input:
AT+MCNTO=300 <enter>
Response:
OK
AT+MSDBE
Command Syntax
Enables/Disables the system default button
located on the front of the IPn3G (CONFIG)
AT+MNTP=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MSDBE=1 <enter>
Response:
OK
The AT&W command
must be issued to save
changes!