Microhard Systems IPN3G - Page 170

© Microhard Systems Inc. 170
5.0 AT Commands
AT+MCTUPMP
Command Syntax
Set COM2 UDP Point-to-Multipoint as point
parameters when IP Protocol Mode is set to
UDP Point-to-Multipoint (P)
AT+MCTUPMP=<Multicast IP>, <Multicast
Port>, <Listener Port>, <Time to live>
Description
Example
Input:
AT+MCTUPMP=224.1.1.2,20002,20012,1<enter>
Response:
OK
AT+MCTUPMM
Command Syntax
Set COM2 UDP Point-to-Multipoint as MP
parameters when IP Protocol Mode is set to
UDP Point-to-Multipoint (MP)
AT+MCTUPMM=<Remote IP>, <Remote
Port>, <Multicast IP>, <Multicast Port>
Description
Example
Input:
AT+MCTUPMM=0.0.0.0,20012,224.1.1.2,20002<enter>
Response:
OK
AT+MCTUMPMP
Command Syntax
Set COM2 UDP Multipoint-to-Multipoint
parameters when IP Protocol is set to UDP
Multipoint-to-Multipoint mode.
AT+MCTUMPMP=<Multicast IP>,
<Multicast Port>, <Time to live>, <Listen
Multicast IP>, <Listen Multicast Port>
Description
Example
Input:
AT+MCTUMPMP=224.1.1.2,20012,1,224.1.1.2,20012<enter>
Response:
OK
The AT&W command
must be issued to save
changes!