Microhard Systems IPN3G - Page 208

© Microhard Systems Inc. 208
Appendix H: “system.conf” File Structure (12 of 25)
#Data Baud Rate: A - 300 B - 600 C - 1200 D - 2400
# E - 3600 F - 4800 G - 7200 H - 9600 I - 14400 J - 19200
# K - 28800 L - 38400 M - 57600 N - 115200 O - 230400
# P - 460800 Q - 921600
USB_Data_Baud_Rate=N
#Data Format: A - 8N1 B - 8N2 C - 8E1 D - 8O1 E - 7N1
# F - 7N2 G - 7E1 H - 7O1 I - 7E2 J - 7O2
USB_Data_Format=A
#Data Mode: A - Seamless B - Transparent
USB_Data_Mode=B
#Character Timeout:
USB_Character_Timeout=0
#Maximum Packet Size:
USB_Max_Packet_Len=1024
#Priority: A - Normal B - Medium C - High
USB_QoS=A
#No-Connection Data Intake: A - Disable B - Enable
USB_NoConnect_Data_Intake=B
#Modbus TCP Config...
USB_MODBUS_Mode=A
#IP Protocol Config A - TCP Client B - TCP Server C - TCP Client/Server
# D - UDP Point to Point E - UDP Point to Multipoint(P)
# F - UDP Point to Multipoint(MP) G - UDP Multipoint to Multipoint
USB_IP_Protocol=F
#Remote Server IP Address:
USB_T_Client_S_Addr=0.0.0.0
#Remote Server Port:
USB_T_Client_S_Port=20003
#Outgoing Connection Timeout:
USB_T_Client_Timeout=60
#TCP Server Polling Mode: A - Monitor B - Multi-polling
USB_T_Server_Polling_Mode=A
#Multi-polling Timeout(ms):
USB_T_Server_Polling_Timeout=100
#Local Listening Port:
USB_T_S_Listen_Port=20003
#Incoming Connection Timeout:
USB_T_S_Timeout=300
#Remote IP Address:
USB_U_PtoP_R_Addr=0.0.0.0
#Remote Port:
USB_U_PtoP_R_Port=20003
#Listening Port:
USB_U_PtoP_L_Port=20003
#UDP Timeout(s):
USB_U_PtoP_Timeout=10