Microhard Systems IPN3G - Page 39

© Microhard Systems Inc. 39
4.0 WebUI Configuration
V3 User Read Write Limit
Defines accessibility of SNMPv3; select either Read Only or Read/Write
priority. If Read Only is selected, the SNMPv3 user may only read
information; if Read Write is selected, the SNMPv3 user may read and
write (set) variables.
Read Only
Read Write
Values
V3 User Authentication Level
Defines SNMPv3 user’s authentication level.
NoAuthNoPriv: No authentication, no encryption.
AuthNoPriv: Authentication, no encryption.
AuthPriv: Authentication, encrpytion.
NoAuthNoPriv
AuthNoPriv
AuthPriv
Values
V3 Authentication Password
SNMPv3 user’s authentication password. Only valid when V3 User
Authentication Level set to AuthNoPriv or AuthPriv (see above).
00000000
Values (char string)
V3 Authentication Password
SNMPv3 user’s encryption password. Only valid when V3 User
Authentication Level set to AuthPriv (see above).
00000000
Values (char string)
SNMP Trap Version
Select which version of trap will be sent should a failure
or alarm condition occur.
V1 Traps
V2 Traps
V3 Traps
Values
Auth Failure Traps
If enabled, an authentication failure trap will be generated upon
authentication failure.
Disable / Enable
Values
Trap Community Name
The community name which may receive traps.
TrapUser
Values (char string)
V1&V2 Traps
V1&V2&V3 Traps
Trap Manage Host IP
Defines a host IP address where traps will be sent to (e.g. SNMP
management system PC IP address).
0.0.0.0
Values