Microhard Systems IPN3G - Page 61

© Microhard Systems Inc. 61
4.0 WebUI Configuration
Protocol Config (continued)
SMS AT Mode: When set to SMS AT Mode, the serial port accepts the SMS AT subset of the AT
Command Set. Only SMS AT Commands are available. For more detailed information about specific
commands, refer to the Section 5: AT Commands. The following commands are available on the COM1
serial port:
 AT+CMGR - Read Message
 AT+CMGL - List Message
 AT+CMGD - Delete Message
 AT+CMGS - Send SM to Network
 AT+CGMI - Request Manufacturer ID
 AT+CGMM - Request Model ID
 AT+CGMR - Request Revision
 AT+CSQ - Signal Strength
 AT+MMGR - Read Message (Does not change Status)
 AT+MMGL - List Message (Does not change Status)
 AT+CMFG - Message Format
 AT+CCLK - Read System Date and Time
 AT+CSCA - Service Center Address
 AT+CREG - Network Registration Status
 AT+CNMI - New Message Indications to Terminal
 AT+CMTI - Stored SMS-DELIVER Indication Unsolicited Response
GPS Transparent Mode: When in GPS Transparent Mode, GPS data is reported out of the serial port.
Sample output is shown below:
Image 4-28: COM > GPS Transparent Mode