Microhard Systems IPN3G - Page 75

© Microhard Systems Inc. 75
4.0 WebUI Configuration
Source IP
If a valid IP/Network address is specified, the action will apply against that
address; otherwise, leaving the default value of 0.0.0.0/0 in this field results
in the action applying to all source IP addresses.
Values (IP Address)
0.0.0.0/0
Destination Zone
Select the zone which is the intended destination of the data traffic. WAN
applies to the wireless connection to the cellular carrier and the LAN refers
to local connections on the IPn3G (Ethernet, USB NDIS etc)
Values (selection)
WAN
LAN
none
Destination IP
If a valid IP/Network address is specified, the action will apply against that
address; otherwise, leaving the default value of 0.0.0.0/0 in this field results
in the action applying to all source IP addresses.
Values (IP Address)
0.0.0.0/0
Destination Port
This field is used to define a port or service used in the rule (i.e. Port 80 =
HTTP which is generally a web server)
Values (port)
0
Protocol
The protocol field defines the transport protocol type controlled by the rule.
Values
TCP
UDP
ICMP
all
Source Zone
Select the zone which is to be the source of the data traffic. WAN applies
to the wireless connection to the cellular carrier and the LAN refers to local
connections on the IPn3G (Ethernet, USB NDIS etc)
Values
WAN
LAN
none