Micromeritics TriStar II 3020 - Unit Configuration

TriStar II 3020 Unit Configuration
302-42828-01 - Dec 2012 6-15
Unit Configuration
Unit [n] > Unit Configuration
Use to display hardware/software configurations, calibrations and gas selections of the connected
analyzer.
Field or Button Description
Configuration

group box
Displays the IP address used by the analysis program and the serial number
of the selected analyzer.
• Change IP - click to display the Unit IP Setup window. Shows the IP
address and Subnet mask assigned during installation. Do not edit these
fields unless instructed by a Micromeritics service representative.
• Board ID - click to read the board ID. The parameters on this window
cannot be edited.
Software Versions
group box
Displays the software versions of the MIC BIOS, controller and analysis
program.