Defining Parameter Files TriStar II 3020
3-12 302-42828-01 - Dec 2012
Degas Conditions
Degas Conditions files contain degassing information for sample preparation.
1. Go to File > Open
> Degas Conditions.
2. Enter a name in the File name text box. Click Open.
3.
Click OK to create the file.
4. Enter a description in the Description text box.
5. Use the Insert button to enter up to five stages of degassing (soak temperature, ramp rate, and
soak time).
6. Click Save, then click Close. The file saves with a .DEG file extension.
Degassing is a required step in preparation for the analysis; however, this section is
only applicable if using the SmartPrep Degasser. This section contains degassing
instructions that will be sent to the SmartPrep Degasser equipment.
To Next Page
Loading...
