Installing the Software TriStar II 3020
4-10 302-42828-01 - Dec 2012
Starting the Setup Program
To start the setup program:
1. Ensure that the analysis program is not operating and the analyzer is idle.
2. Insert the setup CD into the CD-ROM drive. The setup program starts automatically.
If the program does not start automatically, navigate to the CD drive and double-click the
setup.exe file.
3. The Welcome screen displays. Click
Next.
4. On the Select Task screen, select the task to perform, then click
Next. Use the following sections
to complete the selected task.
To Next Page
Loading...
