Installing the Software TriStar II 3020
4-2 302-42828-01 - Dec 2012
Installing the Software
The following prerequisites must be completed prior to installing the software:
• Configure an Ethernet port on the computer to communicate with the analyzer. Refer to
ETHERNET CONFIGURATION, page D-1.
• Attach the analyzer to the computer’s configured Ethernet port and turn on the power to the
analyzer.
CDs containing calibration files have suffix of 99. Update CDs have a suffix of 00.
1. Insert the installation CD into the CD-ROM drive. The program automatically starts the
installation. If the installation does not immediately start, navigate to the CD-Rom drive, locate
and double-click the setup.exe file.
System Installation videos for hardware components and verification of operation are available by
clicking the Click here to view the system installation videos link on the Ethernet Introduction
screen.
2. The Welcome screen displays. Click Next.
If installing multiple analyzers, connect the Ethernet switch to the computer’s
configured port and connect the analyzers to the Ethernet switch. Refer to
Ethernet
Switch, page 4-13
. Then turn the analyzers on.
The application should not be installed on a network drive with shared access.
Multiple users cannot operate the application at the same time.
To Next Page
Loading...
