TriStar II 3020 Installing the Software
302-42828-01 - Dec 2012 4-3
3. On the Ethernet Introduction screen, verify that all prerequisites have been met. If not, click
Cancel and complete the steps, then restart the installation program. Do not proceed with
installation until these tasks have been completed. If the prerequisites have been met, click Next.
4. On the Choose Users screen, select either of the following, then click Next:
• Install for anyone using this computer - anyone who logs on to this computer will have
access to the analyzer program.
• Install just for me - only the person logged onto the computer at the time of installation will
have access to the analyzer program.
To Next Page
Loading...
