TriStar II 3020 Installing the Software
302-42828-01 - Dec 2012 4-17
Moving an Analyzer from One PC to Another PC
This section provides instructions on moving a configured analyzer (along with its status, calibration,
and log files) from one computer (Source PC) to a another (Destination PC). This operation does not
move sample or parameter files. Use a file management program such as Explorer or a backup/restore
utility to move these types of files.
1. Ensure the analyzer program is installed on the destination computer. If this is a new install, refer
to
Installing the Software, page 4-2 and select ’0’ as the number of analyzers to be installed.
2. Start the setup program on the Source computer. On the Welcome screen, click Next.
3. On the Select Task screen, select Move an analyzer from one PC to another PC. Click Next.
To Next Page
Loading...
