Appendix B TriStar II 3020
B-18 302-42828-01 - Dec 2013
4028- Dubinin calculations cannot be performed because the affinity coefficient of
the analysis gas is zero.
4029- At least two fitted data points are needed for Alpha-S calculations.
4030- Preparations failed in primary data.
4031- Not enough points with a relative pressure in the range [n,n]
4033- Not enough points to generate Dubinin Tabular Report.
4034- Fewer than 2 points available for Dubinin calculations.
Cause: Dubinin values could not be calculated because the affinity
coefficient of the analysis gas is zero.
Action: Access the Dubinin Report Adsorptive options in the sample file and
enter an appropriate value for the analysis gas.
Cause: Fewer than two data points fall within the selected Alpha-s range.
Action: Edit the calculation assignments or the fitted Alpha-s range or use a
different reference curve.
Cause: Appropriate data were not available to generate the report.
Action: This message was preceded by a different error message. Refer to the
cause/action of the preceding message.
Cause: Fewer than two data points selected for the Dubinin report fall within
the selected relative pressure range.
Action: Edit the calculation assignments or the fitted relative pressure range.
Cause: There are fewer than two valid data points available for the Dubinin
tabular reports.
Action: Examine the calculation assignments in the Collected Data window
of the sample file. At least two micropore pressures must be selected
for inclusion in the Dubinin report.
Cause: There are fewer than two valid data points available for Dubinin
reports in one of the sample files selected for overlaying.
Action: Examine the calculation assignments in the Collected Data window
of the sample file. At least two micropore pressures must be selected
for inclusion in the Dubinin report.
To Next Page
Loading...
