SPECIFICATIONS FOR THE SMART VACPREP
The Smart VacPrep degasser has been designed and tested to meet the following specifications:
Specification Description
Backfill Options Automatically backfill or wait for user command
Capacity 6 ports
Degas Method Heat and vacuum
Physical Dimensions Height: 69 cm (27 in.)
Width: 53 cm (20.75 in.)
Depth: 44 cm (17 in.)
Weight: 32 kg (70 lbs)
Evacuation Period Determined by selected elapsed time or achievement of selected low pres-
sure target
Evacuation Rate Selectable evacuation rate from 1.0 to 50.0 mmHg/s
Heating of Samples Heating mantles
Heating Ramp Rate Selectable from 0.1
o
C per minute to 10
o
C per minute
Soak Time Zero to 999 minutes in one minute increments (Zero = Manual Cancel).
Temperature Accuracy Deviation less than ±10
o
C at the sensing thermocouple embedded in the
heating mantle
Temperature Control One ramp during evacuation phase, five additional ramps during sub-
sequent phases
Temperature Range 40 to 450
o
C in one degree increments
Vacuum Control Selectable target pressure controls switchover from restricted to unres-
tricted evacuation.
Specifications for the Smart VacPrep
SET THE VOLTAGE FOR THE SMART VACPREP
The Smart VacPrep voltage setting is housed in a compartment adjacent to the power connector on the
back of the unit.
1. Use a flat head screwdriver to gently pry open the cover of the compartment.
2. Firmly press down on the voltage indicator and roll the indicator to display the appropriate voltage
for your environment. Selections are: 100 Vac, 120 Vac, 230 Vac, and 240 Vac.
3. Firmly press the compartment cover shut. Ensure it closes securely. The selected voltage will
appear in the window on the compartment cover.
Specifications for the Smart VacPrep
Smart VacPrep Operator Manual — 067-42800-01
Dec 2013
1 - 3
To Next Page
Loading...
