TriStar II 3020 Installing the Software
302-42828-01 - Dec 2012 4-19
6. The Analyzer Installer Created screen displays. Click Finish.
a.) Remove the CD from the CD-ROM drive and store in a safe location.
b.) Disconnect the Ethernet cable from the Source computer and reconnect it to the configured
Ethernet port on the Destination computer. If moving the analyzer to a computer that already
has an analyzer attached, an Ethernet switch is required.
c.) If the move destination was a local drive, navigate to the drive and copy the Analyzer SN [n]
Installer.exe file to a media device such as a USB stick. Install the file on the destination
computer, then double-click the Analyzer SN [n] Installer.exe file.
If the move destination was a network drive, navigate to the location then double-click the
Analyzer SN [n] Installer.exe file.
7. The Welcome screen displays. Click Next.
8. On the Move Analyzer screen, click Next.
To Next Page
Loading...
