Programming
166
Existing dispensing data will however only be overwritten following
additional confirmation. Dispensing type, dispensing phase, 1, 2,
(Dispenser pump, dispensing amount and level) and dispensing stop
are listed for each program. Therefore If the detergent is changed
dispensing can be optimized quickly and easily.
Only active dispensing pumps are listed
Select the "Dispensing" menu option.
Dispensing
Data to control unit
:
Dispensing
13:40 10.05.15
When the multifunction selector is pressed, the security question will
appear.
DispensingData to control unit
Overwrite existing data?
Press the "Save" button to confirm.
During data transfer the following appears in the display:
Dispensing
Data to control unit
Tip: If not all dispensing data can be copied from the card into the
controls the following message will appear:
DispensingData to control unit
Insufficient memory
Tip: If copying is not possible as described above the following ap-
pears in the display:
DispensingData to control unit
Data transfer not possible
Program
With this menu option one or more programs can be copied from the
card to the controls.
Tip: Existing programs in the controls will be overwritten.
To Next Page
Loading...
Need help?
General
