# DST-ADDRESS G GATEWAY DISTANCE INTERFACE
0 ADC 10.1.0.0/28 Public1
1 ADC 10.1.1.0/28 Public2
2 ADC 192.168.0.0/24 Local
3 A S 0.0.0.0/0 r 10.1.0.1 Public1
r 10.1.1.1 Public2
r 10.1.1.1 Public2
[admin@ECMP-Router] ip route>
Standard Policy-Based Routing with Failover
This example will show how to route packets, using an administrator defined policy. The policy for
this setup is the following: route packets from the network 192.168.0.0/24, using gateway 10.0.0.1,
and packets from network 192.168.1.0/24, using gateway 10.0.0.2. If GW_1 does not respond to
pings, use GW_Backup for network 192.168.0.0/24, if GW_2 does not respond to pings, use
GW_Backup also for network 192.168.1.0/24 instead of GW_2.
The setup:
Page 135 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...