MikroTik RouterOS v2.9 - Phonejack Voice Ports

To Next Page

To Previous Page

approximate delay time from the moment of receiving an audio packet from the IP network till it is

played back over the telephony voice port. The value shown is never less than 30ms, although the

actual delay time could be less. If the shown value is >40ms, then it is close (+/-1ms) to the actual

delay time.

monitor - monitor status of the voice port ( name ) - port name to monitor ( on-hook | off-hook |

ring | connection | busy ) - current state of the port:

• on-hook - the handset is on-hook, no activity

• off-hook - the handset is off-hook, the number is being dialed

• ring - call in progress, direction of the call is shown by the direction property

• connection - the connection has been established

• busy - the connection has been terminated, the handset is still off-hook

( phone | line ) - the active port of the card

• phone - telephone connected to the card (POTS FXS port)

• line - line connected to the card (PSTN FXO port)

( ip-to-port | port-to-ip ) - direction of the call

• ip-to-port - call from the IP network to the voice card

• port-to-ip - call from the voice card to an IP address

( plugged | unplugged ) - state of the PSTN line

• plugged - the telephone line is connected to the PSTN port of the card

• unplugged - there is no working line connected to the PSTN port of the card

( integer ) - the phone number being dialed ( text ) - name and IP address of the remote party (

name ) - CODEC used for the audio connection ( time ) - duration of the phone call

Notes

When telephone line is connected to the 'line' port, green LED next to the port should be lit in some

seconds. If telephone line disappear, the LED next to the 'line' port will change its state to red in an

hour or when the line is activated (i.e. when somebody calls to/from it). When telephone line is

plugged in the 'phone' port before the router is turned on, red LED next to the port will be lit.

WARNING: do not plug telephone line into the 'phone' port when the router is running and green

LED next to the port is lit - this might damage the card. The status of the 'phone' port is only

detected on system startup.

PhoneJack Voice Ports

Home menu level: /ip telephony voice-port phonejack

Property Description

name ( name ) - name given by the user or the default one

type ( read-only: phonejack | phonejack-lite | phonejack-pci ) - type of the card

autodial ( integer ; default: "" ) - phone number which will be dialed immediately after the

handset has been lifted. If this number is incomplete, then the remaining part has to be dialed on the

dial-pad. If the number is incorrect, busy tone is played. If the number is correct, then the

appropriate number is dialed

Page 661 of 695

Other trademarks and registred trademarks mentioned herein are properties of their respective owners.