MikroTik RouterOS v2.9 - Zaptel Voice Ports

To Next Page

To Previous Page

• phone - telephone connected to the card (POTS FXS port)

• line - line connected to the card (PSTN FXO port)

( ip-to-port | port-to-ip ) - direction of the call

• ip-to-port - call from the IP network to the voice card

• port-to-ip - call from the voice card to an IP address

( plugged | unplugged ) - state of the PSTN line

• plugged - the telephone line is connected to the PSTN port of the card

• unplugged - there is no working line connected to the PSTN port of the card

( integer ) - the phone number being dialed ( text ) - name and IP address of the remote party (

name ) - CODEC used for the audio connection ( time ) - duration of the phone call

Zaptel Voice Ports

Home menu level: /ip telephony voice-port zaptel

Property Description

name ( name ) - name given by the user or the default one

autodial ( integer ; default: "" ) - phone number which will be dialed immediately after the

handset has been lifted. If this number is incomplete, then the remaining part has to be dialed on the

dial-pad. If the number is incorrect, the line is hung up. If the number is correct, then the

appropriate number is dialed (the direct-call mode is used - the line is picked up only after the

remote party answers the call)

playback-volume ( integer : -48 ..48 ; default: 0 ) - playback volume in dB

• 0 - 0dB meand no change to signal level

record-volume ( integer : -48 ..48 ; default: 0 ) - record volume in dB

• 0 - 0dB meand no change to signal level

region ( name ; default: us ) - regional setting for the voice port. This setting is used for setting the

parameters of PSTN line, as well as for detecting and generating the tones

aec ( yes | no ) - wheteher echo detection and cancellation is enabled

aec-tail-length ( short | medium | long ; default: short ) - size of the buffer of echo detection

aec-nlp-threshold ( off | low | medium | high ; default: low ) - level of cancellation of silent sounds

aec-attenuation-scaling ( integer : 0 ..10 ; default: 4 ) - factor of additional echo attenuation

aec-attenuation-boost ( integer : 0 ..90 ; default: 0 ) - level of additional echo attenuation

software-aec ( yes | no ) - software echo canceller (experimental, for most of the cards)

agc-on-playback ( yes | no ; default: no ) - automatic gain control on playback (can not be used

together with hardware voice codecs)

agc-on-record ( yes | no ; default: no ) - automatic gain control on record (can not be used together

with hardware voice codecs)

detect-cpt ( yes | no ; default: no ) - automatically detect call progress tones

Command Description

clear-call - terminate a current call established with the specified voice port ( name ) - port name to

Page 663 of 695

Other trademarks and registred trademarks mentioned herein are properties of their respective owners.