[admin@MikroTik] interface l2tp-client> add name=test2 connect-to=10.1.1.12 \
\... user=john add-default-route=yes password=john
[admin@MikroTik] interface l2tp-client> print
Flags: X - disabled, R - running
0 X name="test2" mtu=1460 mru=1460 connect-to=10.1.1.12 user="john"
password="john" profile=default add-default-route=yes
[admin@MikroTik] interface l2tp-client> enable 0
Monitoring L2TP Client
Command name: /interface l2tp-client monitor
Property Description
status ( text ) - status of the client
• Dialing - attempting to make a connection
• Verifying password... - connection has been established to the server, password verification in
progress
• Connected - self-explanatory
• Terminated - interface is not enabled or the other side will not establish a connection uptime
(time) - connection time displayed in days, hours, minutes and seconds
encoding ( text ) - encryption and encoding (if asymmetric, separated with '/') being used in this
connection
Example
Example of an established connection
[admin@MikroTik] interface l2tp-client> monitor test2
status: "connected"
uptime: 4m27s
encoding: "MPPE128 stateless"
[admin@MikroTik] interface l2tp-client>
L2TP Server Setup
Home menu level: /interface l2tp-server server
Description
The L2TP server creates a dynamic interface for each connected L2TP client. The L2TP connection
count from clients depends on the license level you have. Level1 license allows 1 L2TP client,
Level3 or Level4 licenses up to 200 clients, and Level5 or Level6 licenses do not have L2TP client
limitations.
To create L2TP users, you should consult the PPP secret and PPP Profile manuals. It is also
possible to use the MikroTik router as a RADIUS client to register the L2TP users, see the manual
how to do it.
Property Description
Page 326 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...
General