• Log Management
Description
You can install up to four MOXA C101 synchronous cards in one PC box, if you have so many
slots and IRQs available. Assuming you have all necessary packages and licenses installed, in most
cases it should to be done nothing at that point (all drivers are loaded automatically). However, if
you have a non Plug-and-Play ISA card, the corresponding driver requires to be loaded.
MOXA C101 PCI variant cabling
The MOXA C101 PCI requires different from MOXA C101 ISA cable. It can be made using the
following table:
DB25f Signal Direction V.35m
4 RTS OUT C
5 CTS IN D
6 DSR IN E
7 GND - B
8 DCD IN F
10 TxDB OUT S
11 TxDA OUT P
12 RxDB IN T
13 RxDA IN R
14 TxCB IN AA
16 TxCA IN Y
20 DTR OUT H
22 RxCB IN X
23 RxCA IN V
short 9 and 25 pin
Additional Documents
For more information about the MOXA C101 synchronous 4Mb/s adapter hardware please see:
• http://www.moxa.com/product/sync/C101.htm - the product on-line documentation
• C101 SuperSync Board User's Manual the user's manual in PDF format
Synchronous Interface Configuration
Home menu level: /interface moxa-c101
Page 218 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...
General