Property Description
address ( read-only: MAC address ) - MAC address of the remote host
avg-rxq ( read-only: integer ) - average signal strength of received packets since last display
update on screen
correct ( read-only: percentage ) - how many undamaged packets were received
last-rx ( read-only: time ) - time in seconds before the last packet was received
last-tx ( read-only: time ) - time in seconds when the last TXQ info was received
rxq ( read-only: integer ) - signal strength of last received packet
ssid ( read-only: text ) - service set identifier
txq ( read-only: integer ) - the last received signal strength from our host to the remote one
Example
[admin@MikroTik] interface wireless align> monitor wlan2
# ADDRESS SSID RXQ AVG-RXQ LAST-RX TXQ LAST-TX CORRECT
0 00:01:24:70:4B:FC wirelesa -60 -60 0.01 -67 0.01 100 %
[admin@MikroTik] interface wireless align>
Frequency Monitor
Description
Aproximately shows how loaded are the wireless channels.
Property Description
freq ( read-only: integer ) - shows current channel
use ( read-only: percentage ) - shows usage in current channel
Example
Monitor 802.11b network load:
[admin@MikroTik] interface wireless> frequency-monitor wlan1
FREQ USE
2412MHz 3.8%
2417MHz 9.8%
2422MHz 2%
2427MHz 0.8%
2432MHz 0%
2437MHz 0.9%
2442MHz 0.9%
2447MHz 2.4%
2452MHz 3.9%
2457MHz 7.5%
2462MHz 0.9%
To monitor other bands, change the the band setting for the respective wireless interface.
Page 269 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...
General