bundle-128K ( yes | no ; default: yes ) - use both channels instead of just one
authentication ( pap | chap | mschap1 | mschap2 ; default: mschap2, mschap1, chap, pap ) - used
authentication
Example
ISDN server interfaces can be added using the add command:
[admin@MikroTik] interface isdn-server> add msn="142" bundle-128K=no
[admin@MikroTik] interface isdn-server> print
Flags: X - disabled, R - running
0 X name="isdn-in1" mtu=1500 mru=1500 msn="142"
authentication=mschap2,chap,pap profile=default l2-protocol=x75bui
bundle-128K=no
[admin@MikroTik] interface isdn-server>
ISDN Examples
ISDN Dial-out
Dial-out ISDN connections allow a local router to connect to a remote dial-in server (ISP's) via
ISDN.
Let's assume you would like to set up a router that connects your local LAN with your ISP via
ISDN line. First you should load the corresponding ISDN card driver. Supposing you have an ISDN
card with a W6692-based chip:
[admin@MikroTik]> /driver add name=w6692
Now additional channels should appear. Assuming you have only one ISDN card driver loaded, you
should get following:
[admin@MikroTik] isdn-channels> print
Flags: X - disabled, E - exclusive
# NAME CHANNEL DIR.. TYPE PHONE
0 channel1 0
1 channel2 1
[admin@MikroTik] isdn-channels>
Suppose you would like to use dial-on-demand to dial your ISP and automatically add a default
route to it. Also, you would like to disconnect when there is more than 30s of network inactivity.
Your ISP's phone number is 12345678 and the user name for authentication is 'john'. Your ISP
assigns IP addresses automatically. Add an outgoing ISDN interface and configure it in the
following way:
[admin@mikrotik]> /interface isdn-client add name="isdn-isp" phone="12345678"
user="john" password="31337!)" add-default-route=yes dial-on-demand=yes
[admin@MikroTik] > /interface isdn-client print
Flags: X - disabled, R - running
0 X name="isdn-isp" mtu=1500 mru=1500 msn="" user="john" password="31337!)"
profile=default phone="12345678" l2-protocol=hdlc bundle-128K=no
dial-on-demand=yes add-default-route=yes use-peer-dns=no
Configure PPP profile.
[admin@MikroTik] ppp profile> print
Flags: * - default
0 * name="default" local-address=0.0.0.0 remote-address=0.0.0.0
Page 209 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...
General