DHCP Server Setup
Home menu level: /ip dhcp-server
Description
The router supports an individual server for each Ethernet-like interface. The MikroTik RouterOS
DHCP server supports the basic functions of giving each requesting client an IP address/netmask
lease, default gateway, domain name, DNS-server(s) and WINS-server(s) (for Windows clients)
information (set up in the DHCP networks submenu)
In order DHCP server to work, you must set up also IP pools (do not include the DHCP server's IP
address into the pool range) and DHCP networks.
It is also possible to hand out leases for DHCP clients using the RADIUS server, here are listed the
parameters for used in RADIUS server.
Access-Request:
• NAS-Identifier - router identity
• NAS-IP-Address - IP address of the router itself
• NAS-Port - unique session ID
• NAS-Port-Type - Ethernet
• Calling-Station-Id - client identifier (active-client-id)
• Framed-IP-Address - IP address of the client (active-address)
• Called-Station-Id - name of DHCP server
• User-Name - MAC address of the client (active-mac-address)
• Password - ""
Access-Accept:
• Framed-IP-Address - IP address that will be assigned to client
• Framed-Pool - ip pool from which to assign ip address to client
• Rate-Limit - Datarate limitation for DHCP clients. Format is: rx-rate[/tx-rate]
[rx-burst-rate[/tx-burst-rate] [rx-burst-threshold[/tx-burst-threshold]
[rx-burst-time[/tx-burst-time][priority] [rx-rate-min[/tx-rate-min]]]]. All rates should be
numbers with optional 'k' (1,000s) or 'M' (1,000,000s). If tx-rate is not specified, rx-rate is as
tx-rate too. Same goes for tx-burst-rate and tx-burst-threshold and tx-burst-time. If both
rx-burst-threshold and tx-burst-threshold are not specified (but burst-rate is specified), rx-rate
and tx-rate are used as burst thresholds. If both rx-burst-time and tx-burst-time are not
specified, 1s is used as default. Priority takes values 1..8, where 1 implies the highest priority,
but 8 - the lowest. If rx-rate-min and tx-rate-min are not specified rx-rate and tx-rate values are
used. The rx-rate-min and tx-rate-min values can not exceed rx-rate and tx-rate values.
• Ascend-Data-Rate - tx/rx data rate limitation if multiple attributes are provided, first limits tx
data rate, second - rx data rate. If used together with Ascend-Xmit-Rate, specifies rx rate. 0 if
unlimited
• Ascend-Xmit-Rate - tx data rate limitation. It may be used to specify tx limit only instead of
sending two sequental Ascend-Data-Rate attributes (in that case Ascend-Data-Rate will specify
Page 483 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...
General