EoIP
Document revision 1.4 (Fri Nov 04 20:53:13 GMT 2005)
This document applies to MikroTik RouterOS V2.9
Table of Contents
Table of Contents
General Information
Summary
Quick Setup Guide
Specifications
Related Documents
Description
Notes
EoIP Setup
Property Description
Notes
Example
EoIP Application Example
Description
Example
Troubleshooting
Description
General Information
Summary
Ethernet over IP (EoIP) Tunneling is a MikroTik RouterOS protocol that creates an Ethernet tunnel
between two routers on top of an IP connection. The EoIP interface appears as an Ethernet
interface. When the bridging function of the router is enabled, all Ethernet traffic (all Ethernet
protocols) will be bridged just as if there where a physical Ethernet interface and cable between the
two routers (with bridging enabled). This protocol makes multiple network schemes possible.
Network setups with EoIP interfaces:
• Possibility to bridge LANs over the Internet
• Possibility to bridge LANs over encrypted tunnels
• Possibility to bridge LANs over 802.11b 'ad-hoc' wireless networks
Quick Setup Guide
To make an EoIP tunnel between 2 routers which have IP addresses 10.5.8.1 and 10.1.0.1:
1. On router with IP address 10.5.8.1, add an EoIP interface and set its MAC address:
/interface eoip add remote-address=10.1.0.1 tunnel-id=1 mac-address=00-00-5E-80-00-01 \
\... disabled=no
Page 297 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...
General