Xpeed SDSL Interface
Document revision 1.1 (Fri Mar 05 08:18:04 GMT 2004)
This document applies to MikroTik RouterOS V2.9
Table of Contents
Table of Contents
General Information
Summary
Specifications
Related Documents
Additional Documents
Xpeed Interface Configuration
Property Description
Example
Frame Relay Configuration Examples
MikroTik Router to MikroTik Router
MikroTik Router to Cisco Router
Troubleshooting
Description
General Information
Summary
The MikroTik RouterOS supports the Xpeed 300 SDSL PCI Adapter hardware with speeds up to
2.32Mbps. This device can operate either using Frame Relay or PPP type of connection. SDSL
(Single-line Digital Subscriber Line or Symmetric Digital Subscriber Line) stands for the type of
DSL that uses only one of the two cable pairs for transmission. SDSL allows residential or small
office users to share the same telephone for data transmission and voice or fax telephony.
Specifications
Packages required: synchronous
License required: level4
Home menu level: /interface xpeed
Standards and Technologies: PPP (RFC 1661) , Frame Relay (RFC 1490)
Hardware usage: Not significant
Related Documents
• Package Management
• Device Driver List
• IP Addresses and ARP
• Xpeed SDSL Interface
Page 292 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...