when ( read-only: date ) - log in date and time
Example
To print currently active users, enter the following command:
[admin@rb13] user> active print
Flags: R - radius
# WHEN NAME ADDRESS
VIA
0 feb/27/2004 00:41:41 admin 1.1.1.200
ssh
1 feb/27/2004 01:22:34 admin 1.1.1.200
winbox
[admin@rb13] user>
Router User Remote AAA
Home menu level: /user aaa
Description
Router user remote AAA enables router user authentication and accounting via RADIUS server.
Property Description
accounting ( yes | no ; default: yes ) - specifies whether to use RADIUS accounting
default-group ( name ; default: read ) - user group used by default for users authenticated via
RADIUS server
interim-update ( time ; default: 0s ) - RADIUS Interim-Update interval
use-radius ( yes | no ; default: no ) - specifies whether a user database on a RADIUS server should
be consulted
Notes
The RADIUS user database is consulted only if the required username is not found in the local user
database
Example
To enable RADIUS AAA, enter the following command:
[admin@MikroTik] user aaa> set use-radius=yes
[admin@MikroTik] user aaa> print
use-radius: yes
accounting: yes
interim-update: 0s
default-group: read
[admin@MikroTik] user aaa>
Page 396 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...
General