MikroTik RouterOS v2.9 - Nstreme Settings

To Next Page

To Previous Page

rx-ccq: 21%

current-ack-timeout: 56

current-distance: 56

wds-link: no

nstreme: no

framing-mode: none

routeros-version: "2.9beta16"

last-ip: 25.25.25.2

current-tx-powers: 1Mbps:28,2Mbps:28,5.5Mbps:28,11Mbps:28,6Mbps:27,

9Mbps:27,12Mbps:27,18Mbps:27,24Mbps:27,36Mbps:26,

48Mbps:25,54Mbps:24

[admin@MikroTik] interface wireless>

The 'ess' stands for Extended Service Set (IEEE 802.11 wireless networking).

Nstreme Settings

Home menu level: /interface wireless nstreme

Description

You can switch a wireless card to the nstreme mode. In that case the card will work only with

nstreme clients.

Property Description

enable-nstreme ( yes | no ; default: no ) - whether to switch the card into the nstreme mode

enable-polling ( yes | no ; default: yes ) - whether to use polling for clients

framer-limit ( integer ; default: 3200 ) - maximal frame size

framer-policy ( none | best-fit | exact-size | dynamic-size ; default: none ) - the method how to

combine frames (like fast-frames setting in interface configuration). A number of frames may be

combined into a bigger one to reduce the amount of protocol overhead (and thus increase speed).

The card is not waiting for frames, but in case a number of packets are queued for transmitting, they

can be combined. There are several methods of framing:

• none - do nothing special, do not combine packets

• best-fit - put as much packets as possible in one frame, until the framer-limit limit is met, but

do not fragment packets

• exact-size - put as much packets as possible in one frame, until the framer-limit limit is met,

even if fragmentation will be needed (best performance)

• dynamic-size - choose the best frame size dynamically

name ( name ) - reference name of the interface

Notes

Such settings as enable-polling, framer-policy and framer-limit are relevant only on Access

Point, they are ignored for client devices! The client automatically adapts to AP settings.

WDS for Nstreme protocol requires using station-wds mode on one of the peers. Configurations

with WDS between AP modes (bridge and ap-bridge) will not work.

Page 255 of 695

Other trademarks and registred trademarks mentioned herein are properties of their respective owners.