state
• 0 - leave the state in the set mode until restart
state ( yes | no ) - whether to enable the 5V output on pins 1-2 of the J11 header
Console Reset Jumper
Description
The J16 jumper on the RouterBOARD 200 may be used as serial console reset pin. If it held short
for at least 10 seconds, then:
• Serial console configuration is reset
• Serial port that serial console will pick by default (usually serial0) is set to 9600 baud 8 bit 1
stop bit no parity (default settings after installation)
• Special flag that prevents any other program except serial console to acquire this port is set
• Router is rebooted
Page 591 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...