EasyManuals Logo

MikroTik RouterOS v2.9 User Manual

MikroTik RouterOS v2.9
709 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #254 background imageLoading...
Page #254 background image
With the introduction of 2.8 release, MikroTik RouterOS supports wide range of Sangoma
Technologies WANPIPE cards. These cards provide a router with the ability to communicate over
T1, E1, RS232, V.35 and X.21 links directly, without the need of external CSU/DSU equipment.
Property Description
active-channels ( all | integer ; default: all ) - for T1/E1 channels only. Specifies active E1/T1
channel set
chdlc-keepalive ( time ; default: 10s ) - Cisco-HDLC keepalive interval in seconds
clock-rate ( integer ; default: 64000 ) - internal clock rate in bps
clock-source ( internal | external ; default: external ) - specifies whether the card should rely on
supplied clock or generate its own
frame-relay-dce ( yes | no ; default: no ) - specifies whether the device operates in Data
Communication Equipment mode. The value yes is suitable only for T1 models
frame-relay-lmi-type ( ansi | ccitt ; default: ansi ) - Frame Relay Line Management Interface
Protocol type
framing mode ( CRC4 | D4 | ESF | ESF-JAPAN | Non-CRC4 | Unframed ; default: ESF ) - for
T1/E1 channels only. The frame mode:
• CRC4 - Cyclic Redundancy Check 4-bit (E1 Signaling, Europe)
• D4 - Fourth Generation Channel Bank (48 Voice Channels on 2 T-1s or 1 T-1c)
• ESF - Extended Superframe Format
• Non-CRC4 - plain Cyclic Redundancy Check
• Unframed - do not check frame integrity
line-build-out ( 0dB | 7.5dB | 15dB | 22.5dB | 110ft | 220ft | 330ft | 440ft | 550ft | 660ft | E1-75 |
E1-120 ; default: 0dB ) - for T1/E1 channels only. Line Build Out Signal Level.
line-code ( AMI | B8ZS | HDB3 ; default: B8ZS ) - for T1/E1 channels only. Line modulation
method:
• AMI - Alternate Mark Inversion
• B8ZS - Binary 8-Zero Substitution
• HDB3 - High Density Bipolar 3 Code (ITU-T)
line-protocol ( cisco-hdlc | frame-relay | sync-ppp ; default: sync-ppp ) - line protocol
media-type ( E1 | T1 | RS232 | V35 ; default: V35 ) - the hardware media used for this interface
mtu ( integer ; default: 1500 ) - Maximum Transmission Unit for the interface
name ( name ; default: sangomaN ) - descriptive interface name
Page 240 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MikroTik RouterOS v2.9 and is the answer not in the manual?

MikroTik RouterOS v2.9 Specifications

General IconGeneral
BrandMikroTik
ModelRouterOS v2.9
CategorySoftware
LanguageEnglish