RADIUS disconnect and Change of Authorization (according to RFC3576) are supported as well.
These attributes may be changed by a CoA request from the RADIUS server:
• Mikrotik-Group
• Mikrotik-Recv-Limit
• Mikrotik-Xmit-Limit
• Mikrotik-Rate-Limit
• Ascend-Data-Rate (only if Mikrotik-Rate-Limit is not present)
• Ascend-XMit-Rate (only if Mikrotik-Rate-Limit is not present)
• Mikrotik-Mark-Id
• Filter-Id
• Mikrotik-Advertise-Url
• Mikrotik-Advertise-Interval
• Session-Timeout
• Idle-Timeout
• Port-Limit
Note that it is not possible to change IP address, pool or routes that way - for such changes a user
must be disconnected first.
Attribute Numeric Values
Name VendorID Value
RFC where it is
defined
Acct-Authentic 45 RFC2866
Acct-Delay-Time 41 RFC2866
Acct-Input-Gigawords 52 RFC2869
Acct-Input-Octets 42 RFC2866
Acct-Input-Packets 47 RFC2866
Acct-Interim-Interval 85 RFC2869
Acct-Output-Gigawords 53 RFC2869
Acct-Output-Octets 43 RFC2866
Acct-Output-Packets 48 RFC2866
Acct-Session-Id 44 RFC2866
Acct-Session-Time 46 RFC2866
Acct-Status-Type 40 RFC2866
Acct-Terminate-Cause 49 RFC2866
Ascend-Client-Gateway 529 132
Page 389 of 695
Copyright 1999-2007, MikroTik. All rights reserved. Mikrotik, RouterOS and RouterBOARD are trademarks of Mikrotikls SIA.
Other trademarks and registred trademarks mentioned herein are properties of their respective owners.
To Next Page
Loading...
General