If the dot position is misaligned
4-25
4
Maintenance
9
Check the position where the drawn pattern is in
one straight line.
• In the case of the figure in the right, you will notice that a
straight line is formed at the point +140.
10
Adjust it by pressing or key.
• Setting value : 0 to 400
• When there is no pattern forming a straight line between 0 and
400
(1) Once again, perform the checking of the head gap ( P.3-6 ).
(2) Perform the procedures from the Step 1.
11
Press the key.
12
Press the key several times to end the setting.
To Next Page
Loading...
