3-24
Switch the drawing range when using the post cure function
When the Post Cure Unit is used, as the depth of the Y bar increases by the Post Cure Unit, the movable area of
the Y bar narrows compared to that of the JFX-1631/1615, and therefore, the drawing range also narrows.
By setting as below to perform UV irradiation with the post cure after drawing is completed, you can draw in the
same manner as JFX-1631/1615.
1
Press the key in the local mode.
2
Select the [MAINTENANCE] by pressing the or
key and press the key.
3
Select the [DRAWING RANGE] by pressing the
or key.
4
Press the key.
5
Press the or key to select a value and press
the key.
Cure Print : Perform UV irradiation with the post cure at the same
time of drawing.
after print : Perform UV irradiation with the post cure after drawing is
completed.
• When you do not change the current setting value, press the
key and then proceed to the Step 7.
6
Press the key.
• Performs the origin detection operation.
7
Press the key several times to end the setting.
Value Outline
Cure Print
UV irradiation with the post cure is performed at the same time of drawing.
In such a case, the drawing range narrows compared to that when not performing UV irradiation
with the post cure. For details, refer to P.3-21 “Note when using Post Cure Unit”.
after print
After drawing is completed, UV irradiation with the post cure is performed.
When it is set to “after print”, you can draw in the equivalent area of JFX-1631/1615.
In such a case, to perform UV irradiation, the work by the customer is required. Refer to P.3-28
“Enlarge the irradiation area of the post cure”.
• When the setting value is “after print”, the Y bar comes to front by 150mm compared to when it is set to
“Cure Print”. Do not place your hand or an object in front of the Y bar.
To Next Page
Loading...
