MIMAKI JFX-1631/1615 - How to Shake an Ink Cartridge

4-6
How to shake an ink cartridge
1
Wrap the tip of an ink cartridge with paper towel.
2
Slowly shake the ink cartridge more than twenty times right and left.
• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the
upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels.
Then, shake it more than twenty times right and left so that ink flows inside the cartridge.
• If you shake it too strong, the pack inside may be damaged and it may cause ink
leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt
the cartridge until it becomes vertical.
Wrap the tip with paper towel. Tape both ends of the paper towel on
the cartridge.
A part
(the place to stick a
needle)
B part
(the slot on the
bottom)
Cover with paper towel firmly and shake ink slowly
Repeat
this
A part