4-12
Cleaning of wiper
A wiper sweep ink stuck to a nozzle of the head.
The wiper becomes tainted with ink or dusts during the operation of the device.
In order to maintain good condition of the heads, clean the wipers frequently.
1
Turn ON the power.
2
Open the right maintenance cover.
• Remove the screws (2 pcs) and open the right maintenance
cover.
3
Select the “STATION” in the maintenance menu.
(1) Press the key in the local mode.
(2) Select the [MAINTENANCE] by pressing the or key, and press the key.
(3) Press the key again.
4
Select the [MENT:WIPER EXCHG] by pressing the
or key.
5
Press the key.
• The carriage automatically moves from the standby position to the left
front cover on the left.
• The wiper will move toward you.
6
Remove suction nozzle Assy.
(1) Hold down the rear part of the suction nozzle Assy.
(2) Push the protrusion in front to back
(3) Pull up the suction nozzle Assy.
• The wiper is a consumable material. If the drawing images are not improved by repeated head cleaning
after cleaning the wiper, replace the wiper with the supplied wiper for replacement. (Wiper for
replacement: SPC-0515 [30 pieces])
• When conducting the cleaning, be sure to wear the supplied goggle and gloves since you may get ink in
your eyes.
• Do not remove the unspecified parts.
FUNCTION
To Next Page
Loading...
