4-13
Cleaning of wiper
4
Maintenance
7
Remove the wiper M with tweezers.
8
Drip wiper M with several drops of cleaning liquid
and clean it with nonwoven cloth.
• Avoid using the material that will leave dust or fiber after use
such as paper towel.
• When remarkable deformation or wear is seen on the wiper M,
replace it with the new one.
9
Check the inside of the suction nozzle and clean
them if they are dirty.
(1) Remove hardened ink or the attached dirt using a stick
with fine tip.
(2) Using the dropper, drip several drops of cleaning liquid
inside the suction nozzle and clean with nonwoven cloth.
10
Check around the O ring under the suction nozzle,
and clean it if it is stained.
• Around the O ring, uncured ink is sticking. Wipe it out with
nonwoven cloth.
11
Remove the O ring with tweezers, and clean it.
12
Attach the wiper M to the suction nozzle.
• Adjust the wiper M and the suction nozzle so that they are on
the same height.
To Next Page
Loading...
