MIMAKI JFX-1631/1615 - Checking UV ink curing level

4-36
Checking UV ink curing level
As the UV LED is deteriorated, the ink curing level may be lowered.
Check the UV ink curing level and adjust the UV LED light intensity, if necessary.
1
Set media for drawing patterning on the table.
• Turn the vacuum switch ON. After that, set the drawing origin.
2
Make sure that the local mode is displayed.
3
Press the key.
4
Select [HARDEN CHK] by pressing the or
keys.
5
Press the key.
6
Select resolution by pressing the or keys.
• Setting value: 600x300 dpi,600x600 dpi,600x1200 dpi,
1200x300 dpi,1200x600 dpi,1200x1200 dpi
7
Press the key.
8
Select drawing quality by pressing the or
keys.
• Setting value : STANDRD, FINE, FAST
9
Press the key.
10
Select the scanning direction pressing or
keys.
• Setting value : BI-D , UNI-D
TEST DRAW
NOZ Z L E CHK < ENT >
TEST
TEST DRAW
HARDEN CHK <ENT >
HARDEN CHECK
DPI : 300X300
ENTER
HARDEN CHECK
DPI : 1200X1200
HARDEN CHECK
QAL I TY : STANDRD
ENTER
HARDEN CHECK
QAL I TY : F I NE
HARDEN CHECK
SCAN D I R : B I - D
ENTER
HARDEN CHECK
SCAN D I R : UN I - D